Compuprint SP40 Uživatelský manuál stáhnout pdf (Strana 41)

Setup Parameter Values Description

CR=LF+CR

LF=LF+CR

LF&CR=LF+CR

If the printer receives a CR code (CR), it performs a carriage return

followed by a line feed. If the printer receives a LF code (LF), it

performs a line feed.

If the printer receives a LF code (LF), it performs a line feed followed

by a carriage return. If the printer receives a CR code (CR), it only

performs a carriage return.

If the printer receives a LF code (LF) or a CR code (CR), it performs

both a line feed and a carriage return.

WRAP MODE truncate, autowrap The data exceeding the line length are truncated (truncate) or

printed on the following line (autowrap).

REFERENCE EDGE left, rigth Document reference on left or right, for software compatibility.

SLASHED ZERO no, yes Selects the printing character for zero, with a slash (yes) or

without (no).

EJECT ON FF no, yes Performs a form feed according to the selected page format (no) or

ejects a cut sheet loaded into the printer (yes).

RESET WITH EJECT no, yes

When the printer receives a reset command, if this item is set to yes

the paper inserted in the printer is ejected. If the item is set to no the

printer performs only the reset command.

CUT SHEET EJECT on front, on rear Selects whether the cut sheet loaded into the printer is ejected

towards the front or the rear of the printer.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 71 72

Žádné komentáře

Compuprint SP40 Uživatelský manuál Strana 41